FM Approved.
Approved to FM Standard 4985. Sealing heights of 0.30, 0.45 and 0.61 m.
Fire Spillbarrier
Made to measurePrice on request|Data sheet
FM Approved Standard 4985. Tested in a 50 MW fire. Made in Germany.
0MW
Fire test
0min
Leakproof in fire
Up to
0.00m
Width (6.50 m on request)
0.00t
Per wheel
How it works.
Choose your finish.
Stainless steel
Request your quote for the Fire Spillbarrier with Stainless steel finish.
Request a quote
Built for the heat.
The first barrier of its kind with FM approval. Three patents protect the technology.
50 MW fire test.
30 minutes in a 50 MW fire without leakage. Heat absorbing technology keeps the seals tight.
Ready in daily traffic.
Forklifts and trucks cross it every day. The seals stay protected in the tray.
When it burns, every second counts.
The barrier closes automatically. It needs no alarm, no power and no staff.
Options.
Warning signal
A limit switch in the post triggers a warning light or an alarm.
ATEX version
For zones with an explosive atmosphere.
Building management
Status message to your building management system.
Custom colour
Foil in your brand colours so the barrier matches your building.
Which barrier is right for you?
Compare by
Key data
Water Spillbarrier
Made to measure
Made in GermanyFloodNo power needed
2.40 m
Maximum height
45 m
Maximum width
72 h
Leakproof, RW TÜV
3.25 t
Per wheel
Fire Spillbarrier
Made to measure
Made in GermanyFireFM Approved 4985
0.61 m
FM approved height
4.05 m
FM approved width
50 MW
Fire test
3.25 t
Per wheel
Chemical Spillbarrier
Made to measure
Made in GermanyChemicalsPTFE seals
2.40 m
Maximum height
45 m
Maximum width
700 °C
Fire tested by DMT
3.25 t
Per wheel
Good to know.
No. The Fire Spillbarrier is purely mechanical. It needs no electricity and no hydraulics. The liquid lifts the flap and springs seal it.
FM approved sealing heights are 0.30 m (12 in), 0.45 m (18 in) and 0.61 m (24 in). Widths from 1.05 m (3.5 ft) to 4.05 m (13.3 ft). Larger sizes up to 1.20 m high and 6.50 m wide on request.
Yes. We can fit a limit switch in the post. An electrician connects it to a warning light, an alarm or your building management system.
Because the flap lies flat in its tray and passes the load straight into the ground. TÜV tested it with 200,000 crossings at a forklift axle load of 6.5 t, which means 3.25 t per wheel.
Yes. We adapt the barrier to the conditions on site and can build it into any slope.
Yes. The springs carry most of the weight. Lift the flap slightly and the springs swing it up. Clean the tray, then fold the flap back down by hand.
Get your Fire Spillbarrier.
Send us the size of your opening and we send you a free quote. No obligation.