Holds the water back.
The flap rises with the water and seals the opening. 72 h leakproof, certified by RW TÜV.
Water Spillbarrier
Made to measurePrice on request|Data sheet
Stainless steel. No power needed. Made in Germany.
How it works.
Fully automatic. No power needed.
The barrier lies flat in the floor for years. When water comes, it closes within seconds.
Seals stay protected.
In the open position the seals sit protected inside the tray, away from dirt and traffic.
Built into your floor.
Installation depth of only 8 to 15 cm. We install it or train your team.
Built for daily traffic.
TÜV tested with 200,000 forklift crossings. Rated for 3.25 t per wheel.
Options.
Warning signal
A limit switch in the post triggers a warning light or an alarm.
Building management
Status message to your building management system.
Custom colour
Foil in your brand colours so the barrier matches your building.
Stainless steel 316L
AISI 304 as standard. 316L for coastal areas and aggressive media.
Any slope
Can be built into sloped ramps and driveways.
Which barrier is right for you?
Compare by
Key data
Water Spillbarrier
Made to measure
Made in GermanyFloodNo power needed
2.40 m
Maximum height
45 m
Maximum width
72 h
Leakproof, RW TÜV
3.25 t
Per wheel
Fire Spillbarrier
Made to measure
Made in GermanyFireFM Approved 4985
0.61 m
FM approved height
4.05 m
FM approved width
50 MW
Fire test
3.25 t
Per wheel
Chemical Spillbarrier
Made to measure
Made in GermanyChemicalsPTFE seals
2.40 m
Maximum height
45 m
Maximum width
700 °C
Fire tested by DMT
3.25 t
Per wheel
Good to know.
No. The barrier is purely mechanical. Rising water lifts the flap and springs seal it.
The sealing height goes from 0.30 m to 2.40 m. The width follows your opening. The widest barrier built so far is 47 m. Every barrier is made to measure.
Yes. We can fit a limit switch in the post. An electrician connects it to a warning light, an alarm or your building management system.
Because the flap lies flat in its tray and passes the load straight into the ground. TÜV tested it with 200,000 crossings at a forklift axle load of 6.5 t, which means 3.25 t per wheel.
Yes. We adapt the barrier to the conditions on site and can build it into any slope.
Yes. The springs carry most of the weight. Lift the flap slightly and the springs swing it up. Clean the tray, then fold the flap back down by hand.
Get your Water Spillbarrier.
Send us the size of your opening and we send you a free quote. No obligation.